Relays

A low power version of the USB-RLY16 module, the USB-RLY16L is powered solely from the USB bus and provides eight volt free contact relay outputs with a current rating of up to 16Amp each.  The relays are SPCO (Single Pole Change Over) types and provide position 0, position 1 and common pins (l..

Controlled from over Ethernet using simple TCP/IP commands. The ETH-RLY02 provides two volt free contact relay outputs with a current rating of up to 16Amp each. The module is power from a 12vdc supply which can be regulated or unregulated. The DC input jack is 2.1mm with positive core polarity, DC..

The ETH0621 offers 6 digital inputs (accepting 10V - 24V), 2 independently switched 24V 5A outputs  and a 24 volt, 5A motor controller that effortlessly integrates motion control over Ethernet. The ETH0621 also includes a motor surge protection circuit that shuts the motor down in the event of ..

The USB-RLY02 provides two volt free contact relay outputs with a current rating of up to 16Amp each. The USB-RLY02 is powered and instructed from any standard USB bus and does not require any additional power. The relays are SPCO (Single Pole Change Over) types. The normally open, normally closed a..

The SCR02 is a sensor controlled relay module capable of autonomous operation. The SRC02 may be connected to most of our ultrasonic rangers or to 0-5v analogue inputs. A standard 12vdc power is required.   The operation of the SCR02 is configured using the free configuration utility descri..

The USB-RLY82 provides two volt free contact relay outputs with a current rating of up to 1Amp each. It is powered from any standard USB bus and has an exceptionally low maximum current consumption of approx 90mA with all relays on. The relays are SPCO (Single Pole Change Over) types. The normally o..

The ETH8020 provides 20V free contact relay outputs with a current rating of up to 16Amp each and 8 analogue inputs. The module is powered from a 12vdc supply which can be regulated or unregulated. The DC input jack is 2.1mm with positive core polarity, DC supplies are required to supply at least 1A..

Please note this device in NOT licenced for the UK and EU (315MHz) and it is not legal to use here. Please check the laws of your country before purchasing and using this device. We can only sell this product to countries outside of the EU.A wireless relay is a codec-adaptive RF receiver with single..

Please note this device in NOT licenced for the UK and EU (315MHz) and it is not legal to use here. Please check the laws of your country before purchasing and using this device. We can only sell this product to countries outside of the EU.This remote switch allows you to remotely control any 12 Vol..

The ETH484 provides four volt free contact relay outputs with a current rating of up to 16 Amp each, 8 digital I/O and 4 analogue inputs. The relays are SPCO (Single Pole Change Over) types. The normally open, normally closed and common pins are all available on the screw terminals. The module is p..

Controlled from over Ethernet using simple TCP/IP commands. The ETH008 provides eight volt free contact relay outputs with a current rating of up to 16Amp each. The module is powered from a 12vdc supply which can be regulated or unregulated. The DC input jack is 2.1mm with positive core polarity, D..

A low power version of the USB-RLY16 module, the USB-RLY16L is powered solely from the USB bus and provides eight volt free contact relay outputs with a current rating of up to 16Amp each.  The relays are SPCO (Single Pole Change Over) types and provide position 0, position 1 and common pins (l..