At the beginning,the inertial measurement unit is an electronic device that measures and reports on a craft's velocity, orientation, and gravitational forces, using a combination of accelerometers,gyroscopes, and magnetometers. Now IMUs are commonly used in the Human-computer interaction(HCI), navig..
This is a Gear Motor with Encoder, model No. GB37Y3530-12V-90EN. It is a powerful 12V motor with a 90:1 metal gearbox and an integrated quadrature encoder that provides a resolution of 64 counts per revolution of the motor shaft, which corresponds to 5756 counts per revolution of the gearbox’s outpu..
This is a Gear Motor w/Encoder, model No. GB37Y3530-12V-90EN. It is a powerful 12V motor with a 90:1 metal gearbox and an integrated quadrature encoder that provides a resolution of 64 counts per revolution of the motor shaft, which corresponds to 5756 counts per revolution of the gearbox’s ..
This is a DFRobot customised high quality DC motor. The best part of this motor is that it is a quiet and high torque output motor with optical encoder built in. The optical encoder gives 663 pulses per rotation which is able to sense 0.54 degree rotation from the shaft. The resolution can meet gene..
This DC motor has an integrated transistor built in to the board, eliminating the need for a motor driver. Use PWM to control it for all your DIY project needs. It uses the 3 pin "gravity" interface saving lots of messy wiring.
Operating Voltage: 5V
Interface type: Gravity 3-pin dig..
DSS-M15 is a heavy-duty metal gear standard servo with 180° wide angle, high torque power, improved stability and durability.
Able to take in 6V and deliver a strong torque power of over 15kg, this tough 180° servo will never let you down when you need it. Tested with high load capacity for 12 hour..
The DS18B20 is a digital temperature sensor from DALLAS USA. It can be used to quantify the environmental temperature testing.
The sensor reads temperature range -55 ~ +125 ℃, with inherent temperature resolution of 0.5 ℃ and 9-12 bit serial output
Multi-point networking mesh temperature mea..
This is an omni-directional antenna with an IPEX connector. Its working frequency is 2.4GHz which meets most requirements of Wi-Fi devices. Its 6dBi high gain makes for better signal reception and transmission. Specification Frequency: 2.4 GHz Gain: 6dBi Cable length: 15cm Interface Type: IPEX ..
This Gravity Analog 20A current sensor is based on the Hall current sensing principle. It can be used for AC or DC current measurement, has a wide voltage range, a small footprint, requires no soldering and has a high level of precision.We have added high-voltage isolation in the circuit design for ..
This is an affordable 24Mhz 8 Channel USB Logic analyzer. This is a hobbyist level analyzer, ideal for testing your Arduino or other hobbyist microcontroller's communications. A logic analyzer is a must have tool for any serious electronics hobbyist. With a logic analyzer it is possible to see a vis..
DSS-M15S is a heavy-duty metal gear standard servo with 270 degree wide angle, high torque power, improved stability and durability.Able to take in 6V and deliver a strong torque power of over 15Kg, this tough 270 degree servo will never let you down when you need it. Tested with high load capacity ..
This DFRobot Arduino Compatible Motor Shield (2A) uses L298P chip which allow to drive two 7-12V DC motors with maximum 2A current. This shield can be directly mount onto standard Arduino Duemilanoveand Arduino Mega.
The speed control is achieved through conventional PWM which can be obtained from ..