This electret capsule microphone is the same one we use in our great microphone amplifier board. It contains a small vibrating element that will output a few milllivolts peak-to-peak. You will need an op-amp to amplify the signal, some chips are designed with the amplifier built in in which case you..
Add an ear to your project with this well-designed electret microphone amplifier. This fully assembled and tested board comes with a 20-20KHz electret microphone soldered on. For the amplification, we use the Maxim MAX4466, an op-amp specifically designed for this delicate task! The amplifier has ex..
Add an ear to your project with this well-designed electret microphone amplifier with AGC. This fully assembled and tested board comes with a 20-20KHz electret microphone soldered on. For the amplification, we use the Maxim MAX9814, a specialty chip that is designed for amplifying electret microphon..
This small breakout board couples an Electret microphone
(100Hz–10kHz) with a 60x mic preamplifier to amplify the sounds of
voice, claps, door knocks or any sounds loud enough to be picked up by a
microcontroller's analog-to-digital converter. Each breakout comes
fully assembled and works from 2..
That's one tiny microphone! At about the size of a mature aphid, this wired Electret Microphone is perfect for your FONA.
This microphone's very similar to our PCB-mount Elecret Microphone but is significantly smaller and has pre-attached 65mm long wires. We don't have a specific datasheet fo..
Listen to this good news - we now have a breakout board for a super tiny I2S MEMS microphone. Just like 'classic' electret microphones, MEMS mics can detect sound and convert it to voltage, but they're way smaller and thinner. This microphone doesn't even have analog out, its purely digital. The I2S..
The Grove - Loudness Sensor is designed to detect the loudness of environmental sound. Based on amplifier LM2904 and a built-in microphone, it amplifies and filters the high frequency signal that received from the microphone, and outputs a positive envelop. This will make for Arduino’s signal acquis..
This tiny breakout board features the ADMP401 MEMs microphone. One of the key advantages to this breakout and microphone is the bottom ported input. This means the microphone’s input can fit flush against the enclosure of your project. Plus you will not have to deal with trying to solder the microph..
Listen to this good news - we now have a breakout board for a super tiny MEMS microphone. Just like 'classic' electret microphones, MEMS mics can detect sound and convert it to voltage, but they don't need a bias resistor or amplifier, its all in one! The SPW2430 is a small, low cost MEMS mic w..
These earbud headphones are the perfect accessory for your FONA - they've been tested to work with our modules - but can be used with any iOS or Android device that uses a TRRS pinout. The buds themselves are 16mm in diameter with a nice 40" long. They come with a standard 4-pole TR..
The Sound sensor module is a simple microphone. Based on the power amplifier LM386 and the electret microphone, it can be used to detect the sound strength of the environment. The value of output can be adjusted by the potentiometer.
Grove compatible interface
Wide supply voltage rang..
The Xadow Audio integrates a speaker box and a microphone on one single board. The speaker unit is rated at 0.7Watt with an impedance of 8 ohm. Unlike the common cone type speakers, the loudspeaker driver used on the Xadow Audio has a flat surface and is mounted in a rectangular enclosure, which ena..