Shape Memory metals that were developed by NASA for the space industry, and have been used for increasing applications down on earth. For example, there have been limited studies on using these materials in robotics. They make it possible to create very light robots.
The Miga Analog Driver V5 (MAD-..
Grove – MOSFET enables you to control higher voltage projects, for example 15VDC with a low 5V voltage microcontroller. MOSFET is also a kind of switch, but its switching frequency can reach up to 5MHz, much faster than normal mechanical relay. There are two screw terminals on the board. One for out..
In most Arduino projects, relays are the first choice to drive some large current device. It requires a certain amount of current to drive the internal coil to pick-up contact. But for some MCU, like Intel Edison, Intel joule, lilypad, Raspberry Pi and other microcontroller with limited amount of cu..
When you need to switch a lot of power, N channel MOSFETs are best for the job. These FETs can switch over 60A and 30V and are TO-220 package so they fit nicely into any breadboard or perfboard. Heat sinking is easy with TO-220's, but because of the very low Rds(on) of down to 0.009 ohms (depending ..
A simple to use motor shield for the Spark Core and Photon. This board is designed to simplify the process of making small roving robots using a Photon or Spark Core. The shield is designed to be used with low cost robot chassis to make simple autonomous robots.
Dual bi-directional moto..
The DMX MosFet Receiver is a DMX module that mounts four mosfets. They can be individually controlled using a DMX master like TinkerKit’s DMX Master Shield. Each mosfet supports up to 24V DC and the board runs at a range from 12V to 24V. A single master can control up to 512 receivers individually (..
This module switches a high current load using a high power transistor. Unlike a mechanical relay, this is capable of high speed switching for use with PWM.
Output: This module lets you control devices operating at a maximun of 24VDC with an Arduino pin. To wire the module, connect the power supply..