Taking a break

 We're taking a break moving shop and hope to be back soon. We hope to start shipping orders in Nov 2018. 

The MyoWare Muscle Sensor is now designed to be wearable allowing you to attach biomedical sensor pads directly to the board itself. However, there still may be cases where you want to mount the sensor pads away from the other hardware, this is where the MyoWare Cable Shield comes in. This shield provides a 3.5mm jack where you can attach a three electrode sensor cable allowing you to test and use the MyoWare Muscle Sensor without actually attaching it to your person.

The MyoWare Cable Shield is equipped with two rows of 3-pin plated through holes on each end of the board. This allows for standard 0.1" headers to be used to stack the shield with other MyoWare boards.

The MyoWare Muscle Sensor, that this shield attaches to, is an Arduino-powered, all-in-one electromyography (EMG) sensor from Advancer Technologies. The MyoWare board acts by measuring the filtered and rectified electrical activity of a muscle; outputting 0-Vs Volts depending the amount of activity in the selected muscle, where Vs signifies the voltage of the power source.

MyoWare Cable Shield [DEV13687]

  • Brand: Sparkfun
  • Product Code: SPARKFUN-DEV13687
  • Reward Points: 5
  • Availability: 1
  • £6.53

  • Ex Tax: £5.45
  • Price in reward points: 100

Sensor Cable - Electrode  Pads (3 connector) [CAB12970]

Sensor Cable - Electrode Pads (3 connector) [CAB12970]


Simple three conductor sensor cable with electrode pad leads.

Out Of Stock

MyoWare Proto Shield [BOB13709]

MyoWare Proto Shield [BOB13709]


Simple proto-board for your MyoWare Muscle Sensor equipped with two rows of 3-pin plated through ...

Qty: 1

MyoWare Power Shield [DEV13684]

MyoWare Power Shield [DEV13684]


Designed to take two standard CR2032 coin cell batteries to power the MyoWare Muscle Sensor.

Qty: 1