Taking a break

 We're taking a break moving shop and hope to be back soon. We hope to start shipping orders in Nov 2018. 

Zero2Go is a small and smart power supply add-on for Raspberry Pi. When using the pogo pin connector (included in package), it can connect to Raspberry Pi Zero without soldering. It also supports other Raspberry Pi models who have 40-pin header.


  • Same board size with Raspberry Pi Zero
  • No soldering required when mounting on Raspberry Pi Zero
  • Wide range input voltage (5~26V)
  • Reversed polarity protection
  • Connect power source via micro-USB, DC power plug or electric wires
  • Support “pass-through” and “step-down” modes (auto switching)
  • Single tap to startup/shutdown Raspberry Pi

Zero2Go has quite wide input range (5V~26V), so it is will be convenient to power your Raspberry Pi with power bank, Li-Po battery pack, solar panel, car battery or different kinds of power adapters etc.


Zero2Go work in pass through when input voltage is less than 5.5V, and in step-down mode when input voltage is higher than 5.5V. Zero2Go can switch between these two modes automatically.


Parts List

  • Zero2Go board x 1
  • Plastic male-female standoff x 4
  • 5 x 4 mm screws x 4
  • 5 nuts x 4
  • Dual-head Pogo pin connector (5-pin set)

NOTE: Raspberry Pi and 40-pin header are not included in the package.


  • Dimension: 65 x 30 x 9 mm
  • Weight 10g (net weight without any accessory)
  • Input Voltage (Vin) 5~26V  - Input 5.5~7.0V is not recommended as the DC-DC converter needs more dropout to work well.
  • Output Voltage (Vout) 5V (±5% tolerance)
  • Max Output Current 2.6A - Without adding heat sink to DC-DC chip and the inductor (U2 and L1), we suggest to keep the current below 1.5A for long term usage. If you are using the Pogo pin connector to output all current to Raspberry Pi Zero and peripherals, the current should be 1A or lower.
  • DC-DC Efficiency 88% max
  • LED Indicators: Red: lights up when input polarity is reversed; Green: lights up when DC-DC converter is working; Blue: lights up when input pass through to output
  • Static Current ~0.5mA when Vin=5V; ~4mA when Vin=26V - It is the current drawn from the power source, when Raspberry Pi doesn’t get powered.

Software Installation

To install Zero2Go’s software, please run this command in your home directory:

    [email protected] raspberrypi ~ $ wget http://www.uugear.com/repo/Zero2Go/installZero2Go.sh

If your Raspberry Pi has internet connection, it will immediately download the script from our website, and you will then see the “installZero2Go.sh” script in your home directory. Then you just need to this script with with sudo:

    [email protected] ~ $ sudo sh installZero2Go.sh

You will need to use sudo to run this script. This script will copy a file to “/etc/init.d/zero2go”, and register it to run after boot.

Zero2Go: Wide Input Range Power Supply for Raspberry Pi

  • Brand: UUGear
  • Product Code: UUGEAR-ZERO2GO
  • Reward Points: 21
  • Availability: Out Of Stock
  • £26.34

  • Ex Tax: £21.95
  • Price in reward points: 300

Witty Pi 2: Realtime Clock and Power Management for Raspberry Pi

Witty Pi 2: Realtime Clock and Power Management for Raspberry Pi


Witty Pi 2 is the new generation of Witty Pi, which adds RTC and power management to your Raspberry ...

Out Of Stock